KIIT Entrance Examination B.Tech Lateral Entry Sample Question Paper : kiitee.kiit.ac.in
Name of the University : KIIT University
Type of the Exam : KIIT Entrance Examination (KIITEE-2017)
Document Type : Sample Question Paper
Year : 2017
Subject : Basic Electrical Engineering
Department : B. TECH. (LE) (3 YEARS)
Website : https://kiit.ac.in/
Download Model/Sample Question Paper : https://www.pdfquestion.in/uploads/13878-B.techLE.pdf
B.Tech Lateral Entry Sample Question Paper :
Basic Electrical Engineering :
1. A parallel plate capacitor has a capacitance of 2&F. If one of the sides of the plate is doubled and the distance between them is halved, the capacitance of the capacitor is
(A) 1&F
(B) 0.5&F
(C) 2&F
(D) 8&F
Related : KIIT Entrance Examination B.Tech Sample Question Paper 2017 : www.pdfquestion.in/13867.html
2. 1 µF capacitor is connected across a 12 volt battery, its steady state current will be
(A) Zero
(B) 0.001A
(C) 1mA
(D) 5
3. Two resistors each of 4 ohm are connected in parallel. The parallel combination is connected in series with a 2 ohm resistor. If this circuit is connected across a 100Volt supply, the total current drawn is
(A) 20A
(B) 25A
(C) 10A
(D) 16.33A
4. Current flowing through an inductor of inductance 2mH is 5A. The energy stored in the inductor is
(A) 50mJ
(B) 100mJ
(C) 25mJ
(D) 12.5mJ
5. A 1mA ammeter has a resistance of 100ohm. It is to be converted to 1 Amp ammeter. The value of the shunt resistance is
(A) 0.001 ohm
(B) 0.1001 ohm
(C) 100000 ohm
(D) 100 ohm
Engineering Mechanics :
1. In SI Units ,the units of force and power are respectively
(A) Newton and watt
(B) Newton and Pascal
(C) Newton and Joule
(D) Newton and Hertz
2. A number of forces acting at a point will be in equilibrium if
(A) their total sum is zero
(B) sum of the components of this forces resolved in any two mutually perpendicular direction are equal
(C) sum of the components of the forces resolved in any two mutually perpendicular directions are zero each
(D) all the forces are having the same direction.
3. If the resultant of two forces P and Q acting at an angle @ makes an angle B with P, then
(A) tan B = Psin@/Q-Pcos@
(B) tan B = Qsin@/P+Qcos@
(C) tan B Psin@ /PQtan@
(D) tan B Qsin@ /PQtan@
4. A coil having a resistance of 15 ohms and an inductance of 10 henries is connected to 90 volts supply .The value of current after 2 seconds is
(A) 5.345 amp
(B) 5.00 amp
(C) 45.6 amp
(D) None of these
B.Tech : (4 years) – Physics
1. The dimensions of entropy are
(A) M0L-1T0K
(B) M0L-2T0K2
(C) MLT-2K
(D) ML2T-2K-1
2. In a vernier calipers, p divisions of its main scale match with (p+1) divisions on its vernier scale. Each division of the main scale is k units. Using the vernier principle, its least count will be
(A) k(1/p)
(B) (k+1)/p
(C) (p+1)/k
(D) k/(p+1)
Chemistry :
1. Silver nitrate (AgNO3) solution with sodium chloride (NaCl) forms a white colloidal AgCl. Predict the charge on the colloidal AgCl when the amount of AgNO3 is lower than the amount of NaCl.
(A) Neutral
(B) Positive
(C) Negative
(D) Zwitter ionic
2. How easily can you confirm the presence of charcoal powder in MnO2?
(A) Flame test
(B) Dry test tube heating
(C) Addition of water
(D) Heating on a charcoal block
3. Predict the pH of an aqueous solution of 10-8 M HCl.
(A) 8.0
(B)>8.0
(C) <7.0
(D) 0
CSE / CS & IS :
1. A full sub tractor circuit requires ________.
(A) two inputs and two outputs
(B) two inputs and three outputs
(C) three inputs and one output
(D) three inputs and two outputs
2. Give the decimal value of binary 10010.
(A) 6
(B) 9
(C) 18
(D) 20
3. A type of digital circuit technology that uses bipolar junction transistors is ________.
(A) TTL
(B) CMOS
(C) LSI
(D) NMOS
4. The NAND or NOR gates are referred to as “universal” gates because either
(A) can be found in almost all digital circuits
(B) can be used to build all the other types of gates
(C) are used in all countries of the world
(D) were the first gates to be integrated